Swallow Yachts Association

Swallow Yachts Forum => General Discussion => Topic started by: whale on 01 Jun 2023, 21:29

Title: BRE Rowing Seat
Post by: whale on 01 Jun 2023, 21:29
Does anyone have a good design for a rowing seat for the BRE 20 ?  Thanks
Title: Re: BRE Rowing Seat
Post by: Ged on 02 Jun 2023, 13:02
On a boat the size of a BRE the only good rowing seat is one with somebody else sitting in it ;)
Title: Re: BRE Rowing Seat
Post by: RogerLennard on 02 Jun 2023, 14:13
I made some 12ft oars for my BR20 and found that a good rowing seat was the centreboard casing with a foam kneeling mat on it. This is lower than when using the supplied rowing thwart. However, this seemed to be better for the arms when using the long oars.
Title: Re: BRE Rowing Seat
Post by: whale on 10 Jun 2023, 02:17
On a boat the size of a BRE the only good rowing seat is one with somebody else sitting in it ;)
LOL !!!!
Title: Re: BRE Rowing Seat
Post by: whale on 10 Jun 2023, 02:19
I made some 12ft oars for my BR20 and found that a good rowing seat was the centreboard casing with a foam kneeling mat on it. This is lower than when using the supplied rowing thwart. However, this seemed to be better for the arms when using the long oars.
Thanks for the info. 12 FT oars are massive and I can see why you are putting your seat lower.
Title: Re: BRE Rowing Seat
Post by: Nicky R on 11 Jun 2023, 08:46
Mark made a rowing seat for our BRE. He used 3 layers of ply for it that he laminated together. The top two layers were long enough to overlap the seats slightly. The bottom layer was slightly shorter so it went down into the gap between the seats. That stopped it moving backwards and forward because the seats taper on the BRE. Mark made lots of holes in the middle layer using a drill and jigsaw to make the seat lighter. He stuck the layers together with epoxy and put a layer of epoxy on the complete thing, then varnished over the top.

It worked really well - I rowed our BRE for several miles on the raids - but it sounds like you might need to design the BR20 one so that it sits a bit lower down in the boat. Mark says you might not need three layers of ply - he only used that many so that we could sit high enough on the BRE.

Mark also says you need to make sure you have long enough oars, as that’s what makes rowing more efficient!