Swallow Yachts Association

Swallow Yachts Forum => Technical => Topic started by: Craic on 08 Apr 2009, 13:24

Title: Mainsheet Harbourfurl; Foredeck; Rowing bench
Post by: Craic on 08 Apr 2009, 13:24
Finally running out of ideas, just some small stuff left:

1) If you use an intermediate rope between boom and mainsheet pulley, you can leave the mainsheet attached during harbour-furling and harbour-outfurling.

2) The foredeck on my plastic boat is mighty slippery when wet. These 3M non-slip adhesive tapes help.

3) To prevent the rowing bench from sliding while still keeping it adjustable, some Velcro pads help. 

Finally, a happy sailing season to all!
Title: Re: Mainsheet Harbourfurl; Foredeck; Rowing bench
Post by: Craic on 25 Apr 2011, 12:12
Ex-Drascombers like me often take it for granted that people automatically know what is meant by harbourfurling: The vertical furling of the mainsail. Found very little on the web, so am posting a photo here.
Sorry, not possible with roached or battened mainsails. And not really feasible with a conventional mainsail boom.
Title: Re: Mainsheet Harbour furl;
Post by: Colin Morley on 13 May 2011, 09:45
Ex-Drascombers like me often take it for granted that people automatically know what is meant by harbourfurling: The vertical furling of the mainsail. Found very little on the web, so am posting a photo here.
Sorry, not possible with roached or battened mainsails. And not really feasible with a conventional mainsail boom.
I like the idea of the vertical mainsheet furling. In your picture it all looks very neat. How do you roll it up so well when it is attached to the gaff and also include the boom? This looks as though it could be difficult in a wind. Is the boom taken off the gooseneck?  How to you unfurl and raise this sail after a harbour furl?
I have fixed a topping lift which makes it easy to hold the boom horizontally, bring the gaff down to the same level and then "wrap" the sail around this with sail ties. I also have a short rope fixed to the prussic knot on the mizzen which allows me to stabilise the end of the gaff.

Title: Re: Mainsheet Harbourfurl; Foredeck; Rowing bench
Post by: Simon Knight on 12 Aug 2011, 20:38
I have just tried the harbour furl while in the boat is in the garden (less danger of drowning) and found it difficult to get the top of the main rolled tight.  I would imagine that there is the risk of the top of the sail flogging if it is not rolled up enough.

I also tried a topping lift which also acts as a simple lazy jack, it seemed to keep every thing nice and neat so I think I shall give it a go on the water. Also it means that the gaff is in the right place to support the tent.